The lower limit of your shade is factory preset to a closed position that matches the length you ordered. However, you might want to adjust the lower limit to accommodate window hardware or other obstructions. Adjusting the lower limit is easy! Watch this short video, or follow the step-by-step instructions below the video.





Adjusting the Lower Limit of Your Shade


If your remote currently controls a group of shades, you’ll first need to target the specific shade that you want to adjust the lower limit for. See below for steps. If you have one control per shade see Adjust the Lower Limit (section below)


Before You Start - Used for a control that controls a group of shades

If your remote currently controls a group of shades, you’ll first need to target the specific shade that you want to adjust the lower limit for. To do that, perform the following steps first:

  1. On the remote, press and release the program button on the back.
    The remote LED will flash green.
  2.  On the shade you want to adjust, press and hold the program button for 3 seconds.
    The shade LED will flash green and the shade will jog

Even after you target a shade, all of the shades in the group will still move with the remote. However, non-targeted shades won’t accept the new lower limit until you target them specifically.


Adjust the Lower Limit: Two-Button or Single Channel remote

  1. On the remote, press and release the DOWN button. Wait until the shade reaches its preset lower limit.
  2. Press and hold the UP and DOWN buttons at the same time for 3 seconds. When the remote LED turns amber, release both buttons.
    The shade will jog.
  3.  Use the UP and DOWN buttons to move your shade to the new lower limit.

    Don’t attempt to move the lower limit to a position lower than the preset limit—that could damage your shade.

  4. Press and hold the UP and DOWN buttons at the same time for 3 seconds. When the remote LED turns amber, release both buttons.
    The shade will jog. This means you've set your new lower limit!
  5. If you need to adjust another shade's lower limit, go back to the Before You Start section and repeat all the steps for each shade.

Adjust the Lower Limit: Multi-Channel Remote

1. On the remote, press and hold the MENU/RIGHT button for 2 seconds to enter the menu.

2. Select SHADE > LIMITS.

3. To proceed past the warning message, press and hold the MENU/RIGHT button for 2 seconds.

4. Scroll left and right to select the shade you want to adjust the lower limit for.

5. Scroll to UPPER, then press and hold the MENU/RIGHT button for 2 seconds.

If the shade isn't already at the current upper limit, it will move to that position. If the shade is already at the current upperlimit, it will jog.


6. Use the UP or DOWN buttons to move your shade to the new upper limit.

7. Press and release the MENU/RIGHT button to set the upper limit.

The shade will jog. This means you've set your new upper limit


NOTE: If you don't press any buttons for 10 seconds while you're making these adjustments, the remote will time out. If that happens, just start the process over.