Shade will jog when connected to power source – the shade will jog again in approximately 3-10 seconds, this confirms that your remote is paired to the shade. The control will now operate the shade.
If the shade jogs two times (x2) when powered up- this confirms that the remote is not paired to the shade. Follow these steps to pair the remote to the shade:
To pair the controller with the shade- immediately after connecting to power press and release the programming button ~less than 2 seconds the shade will jog to confirm pairing. The control will now operate the shade.
If you do not get a shade jog, follow these steps:
Disconnect the power- at least 2 minutes. Then connect power to the shade, the shade will jog. Press and release the control programming button ~less than 2 seconds. The control will now operate the shade.